Описание

Amplifier Unit NPN
Model EX-V10*1
Type Amplifier Unit NPN
Shape o22 x 35 mm Cylindrical,threaded
Measuring range 0 to 10 mm
A/D converting system ?
Display range -19999 to +19999
Linearity ±0.3% of F.S.
Resolution (No. of averaging measurements: 64) 2 µm
Sampling rate 40000 samplings max./sec. *2
Display speed 20 times/sec.
Display power 7-segment 2-colour LED
Over-range alarm ±FFFF is displayed.
Control input Timing input NPN open-collector or non-voltage contact signal
Reset input
Auto-zero input
Judgment output: Inhibit input
Synchronization/external settings input
Control output NPN open-collector or non-voltage contact (Timing input, Reset input, Auto-zero input, Comparator output disable input, Synchronous input, External setting input)
Controloutput Setting method Upper/lower 2-level setting x 4 patterns (selectable)
Control output Signal NPN open-collector (HIGH, GO and LOW): 100 mA max. (40 V max.)
Controloutput Response time 0.075 ms (at maximum speed)
OFF-delay time 60 ms (ON/OFF selectable)
Strobe output NPN: 100 mA max. (40 V max.), Residual voltage: 1 V max. (N.O.)
Control output Alarm output NPN: 100 mA max. (40 V max.), Residual voltage: 1 V max. (N.C.)
Analogue output voltage Output voltage ±5V
Impedance 100 ?
Response time 0.075 ms (at maximum speed)
Temperature characteristics 0.07% of F.S./°C *3
Major functions FLL, digital filter, auto zero, offset, calculation, measurement mode (15 types), judgment value memory (4 sets), decimal point shift, display digit changing, display of various errors, etc.
Rating Power voltage 24 VDC ±10 %, Ripple (P-P) 10 % or less
Current consumption 240 mA or less
Environmental resistance Ambient temperature 0 to +50 °C
Relative humidity 35 to 85 % RH (No condensation)
Vibration resistance 10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions
Weight Approx. 235 g
*1 The above data was obtained using an iron target (S45C, SS400, t=1 mm). When measuring aluminium, copper, or stainless steel targets, refer to the linear characteristics for these materials. *2 When the digital filter function is used, the sampling rate is 20000 sampling/sec. *3 When the distance between the sensor head and the target is within 50% of the measuring range.
''